All Sailing Parts

All Sailing Parts

2262 products

Everything Nacra, Prindle, Hobie and a few more fun odds and ends.

2262 products

Sort

RONSTAN SHACKLE WITH SWIVEL 1/4" (JAW/JAW)

NACRA INTER 17 FORESTAY 5/32" BARE WITH PIGTAIL

NACRA 5.7 REAR CROSSBAR COMPLETE-USED

CHEATA MOTOR ARM

O'Pen Skiff Dolly

Murrays Part# 65-102555

O'pen Skiff Dolly which disassembles for easy transport into 5 pieces (including2 solid rubber tires with no inner tubes)
Tahe Part# 102555

O'PEN SKIFF DOLLY

N-15 BRIDLE WIRE

ROBLINE SMALL SOFT SHACKLE-12MM SK78

ROBLINE SMALL SOFT SHACKLE-14MM SK78

MAG MOUNT BAR 2 1/2"

N17 Progrip Set

Murrays Part# 56-32324

NACRA 17 progrip set blue/white diamond, is the progrip set for the NACRA 17. From the full foiling version of the NACRA 17, we supplied all the Nacra 17s with this type of progrip.

NACRA 17 PROGRIP SET

NACRA ILLUSTRATED PARTS LIST

Main Fiberglass Batten 100"

Murrays Part# 46-3020-6

Fiberglass battens are stronger and less expensive than foam battens, but also heavier. You trim the batten to the exact length needed (minimum 67").

MAIN FIBERGLASS BATTEN 100"

Main Fiberglass Untapered Batten 107"

Murrays Part# 46-3020-1

Fiberglass battens are stronger and less expensive than foam battens, but also heavier. You trim the batten to the exact length needed (minimum 87-5/16").

MAIN FIBERGLASS UNTAPERED BATTEN 107"

Main Fiberglass Batten Hobie 90"

Murrays Part# 46-3020-7

Fiberglass battens are stronger and less expensive than foam battens, but also heavier. You trim the batten to the exact length needed (minimum 46-1/8").

MAIN FIBERGLASS BATTEN 90"

NACRA 5.0/5.7 TILLER ARM WITH ANGLE 28"

NACRA 6.0 TILLER ARM WITH ANGLE 34.5"

NACRA F16/18INF TILLER TIE BAR ASSEMBLY

NACRA RUDDER HEAD ROLLER

NACRA RUDDER BASE CASTING

Diamond Tang 3-Hole Bottom
Murrays Part# 56-6813
The Prindle Diamond Tang 3-Hole (Bottom) is a 3-hole lower tang for diamond wire is for Prindle 18, 18-2 and 19. Performance Sailing factory item #6813; Nacra Sailing #31444.

PRINDLE DIAMOND TANG 3-HOLE BOTTOM

NACRA F18 INFUSION/N20 OLD STYLE RUDDER BLADE

NACRA SPINNAKER POLE CAP FRONT INTER

Rudder Eye Screw Wide With Bushing

Murrays Part# 56-32055

The screw which is fitted in your lower casting (Until MK2), this screw including the bushing can be adjusted for the rake of the rudder.

NACRA RUDDER EYE SCREW WIDE WITH BUSHING

RONSTAN SERIES 15 BALL BEARING CHEEK BLOCK WITH TWO FASTENING HOLES

Nacra Spring Pin 1/8 x 7/8

Murrays Part# 56-31389

Spring pin 1/8 x 7/8

NACRA SPRING PIN

NACRA RUDDER ROLLER UPPERCASTING

NACRA RUDDER CASTING LOWER TOP INSERT

NACRA RUDDER CASTING LOWER BOTTOM INSERT

NACRA UPPER RUDDER CASTING INSERT

NACRA 15/F16MKII MASTHEAD

NACRA 15 NYLON SPINNAKER HOLMENKOL-BLUE

N-15 FORESTAY-BARE WIRE

N15 Shroud

Murrays Part# 56-32231-2

Shroud NACRA 15 for staymaster 4mm, is a single shroud for the NACRA 15.

The race shroud is provided with a fitting for the Staymaster. When you are looking for a set of shrouds, ordering two pieces is necessary.

N-15 SHROUD-BLACK WIRE

NACRA 15 DAGGERBOARD PORT SIDE

NACRA 15 DAGGERBOARD STARBOARD SIDE

NACRA 15 COMPRESSION POLE

N15 Bowsprit

Murrays Part# 56-32063

Spi pole Nacra 15, is suitable for youth Olympic Nacra 15.

On the critical points of the spi pole, there is an inner tube for extra support.

Supplied with spi pole bridle wires, so the pole is ready to sail.

NACRA 15 BOWSPRIT

N-15 BOWSPRIT BRIDLE-BARE WIRE

N15 Mylar Mainsail-White

Murrays Part# 56-60295-01

Nacra 15 mainsail is made with scrim mylar. Sail comes without battens

NACRA 15 MYLAR MAINSAIL-WHITE

NACRA F20C COMPRESSION POLE (2014 & UP)

Previous 1 … 40 41 42 43 44 … 57 Next

Recently viewed

All Sailing Parts