All Sailing Parts

All Sailing Parts

2261 products

    Everything Nacra, Prindle, Hobie and a few more fun odds and ends.

    2261 products
    NACRA 460 TRAMPOLINE WITH LINE KIT
    Murrays Sports
    Harken 10:1 Mainsheet Carbo Air Base Block Murrays Part# 56-9953 This Carbo AirBlock® has an enormous working range, with a higher working load than a standard block, even though it is lighter in weight. The Carbo Ratchet block allows sailors to hand-hold loaded lines and offers balance between holding power and controlled easing. The base block has an on-off ratchet and will roll freely in both directions when disengaged, such as in light air.
    HARKEN 10:1 MAINSHEET CARBO AIR BASE BLOCK
    Harken
    Spreader Bar 3-Hole Murrays Part# 56-9920 Three-hole spreader bar for Nacra 6.0NA (North American). Nacra Sailing factory item# 30329
    NACRA SPREADER BAR-3 HOLE
    NACRA
    Spreader Bar Aft Murrays Part# 56-9843 Black aft spreader bar for all Nacras. Older Nacras plus Blast and 500 may require the purchase of forward spreader bar (#56-9844) and screws (#56-9851; one per side) to ensure compatibility of all components. Nacra Sailing factory item# 30335
    NACRA SPEADER BAR AFT
    NACRA
    Spreader Tip Plate Murrays Part# 56-9842 Spreader tip plate for all Nacras and Prindle 18, 18.2 and 19. Nacra Sailing factory item# 30316
    NACRA SPREADER TIP PLATE
    NACRA
    NACRA 8' CARBON SNUFFER POLE
    NACRA
    Snuffer Pole Bridle Ring: No Roller Furler Murrays Part# 56-9425 Snuffer pole bridle ring without roller furler for NACRA Inter 20 and NACRA Infusion MKI and MKII . Nacra Sailing factory item# 30216
    NACRA SNUFFER POLE BRIDLE RING: NO ROLLER FURLER
    NACRA
    Mast Head Casting Murrays Part# 56-6902 Mast head casting for Prindle 18-2 and 19. Nacra Sailing factory item# 30459
    PRINDLE MAST HEAD CASTING
    NACRA
    Lower Diamond Tang Murrays Part# 56-6818 Lower diamond tang for Inters and Nacra 500/570 Performance Sports Factory item# 6818 Nacra Sailing# 30196
    NACRA LOWER DIAMOND TANG
    NACRA
    Prindle 18 Mast Head Casting Murrays Part# 56-6802 Mast head casting for Prindle 18 only. Order pin and split ring separately. Nacra Sailing factory item# 30452
    PRINDLE 18 MAST HEAD CASTING
    NACRA
    P18/18.2/19 Mast Hound Murrays Part# 56-6806 Mast Hound for P18, 18-2 and P19 Prindle Part# 6806
    PRINDLE 18/18.2/19 MAST HOUND
    NACRA
    Nacra Carbon Mast Head Yoke Inter 17, 18, 20
    NACRA CARBON MAST HEAD YOKE
    NACRA
    Left Rear Crossbar End Cap Murrays Part# 56-3903 The Prindle Left Rear Crossbar End Cap is for the Prindle 19 and 18-2 cats Performance Sports factory item# 3903
    PRINDLE LEFT REAR CROSSBAR END CAP
    NACRA
    Right Rear Crossbar End Cap Murrays Part# 56-3902 Prindle Right Rear Crossbar End Cap P19, 18-2 is a right rear crossbar end cap for Prindle 19 and 18-2. Performance Sports factory item# 3902
    PRINDLE RIGHT REAR CROSSBAR END CAP
    NACRA
    NACRA REAR CROSSBAR CASTING END CAP-LEFT
    NACRA
    Front Beam Strap Murrays Part# 56-3512 Front beam strap for Nacra 6.0 Nacra Sailing factory item# 30096
    NACRA 6.0 FRONT BEAM STRAP
    NACRA
    Crossbar End Cap Right Rear Murrays Part# 56-3002 The Prindle crossbar end cap for the right rear cross bar on the Prindle 15, 16, 18 and Escape. Performance Sports factory item# 3002
    PRINDLE CROSSBAR RIGHT REAR END CAP
    NACRA
    VERTICAL BOW POLE
    NACRA
    Front Crossbar End Cap Murrays Part# 56-2902 The Prindle Front Crossbar End Cap is for the front crossbar of all Prindles fits both right and left sides. Please specify silver or black and we will do our best to accommodate your selection Nacra Sailing factory item# 30394
    PRINDLE FRONT CROSSBAR END CAP
    NACRA
    Spinnaker Bow Eye Murrays Part# 56-2039 Spinnaker bow eye for Inters Nacra Sailing factory item# 30046
    NACRA SPINNAKER BOW EYE
    NACRA
    Bow Eye Screw 56-1805 Factory stainless steel bow eye screw for Inter 18
    NACRA BOW EYE SCREW
    NACRA
    Vertical Pole Tang Murrays Part# 56-1045 The vertical pole tang is part of the Prindle 19MX Conversion Kit. Performance Sports factory item #1045 is limited to stock on hand.
    NACRA VERTICAL POLE TANG
    NACRA
    PRINDLE EXTENDED GUDGEON
    NACRA
    Nacra Tiller Tie Bar U-Bracket Starboard Murrays Part# 56-0149 Starboard side tiller tie bar U-bracket for Nacra is Nacra Sailing factory item #30149.
    NACRA TILLER TIE BAR U-BRACKET-STARBOARD
    NACRA
    Rudder Pin Wild Cat Murrays Part# 50-F18780330
    WILD CAT RUDDER PIN
    Hobie
    H-14 EUROPEAN DOLPHIN STRIKER ROD
    Murrays Sports
    PRINDLE DOLPHIN STRIKER ROD 12.25" Nacra Sailing factory dolphin striker rod for Prindle 18-2 and 19. This extra long rod measures 12-1/4" long, as needed for some replacements.
    PRINDLE DOLPHIN STRIKER ROD 12.25"
    NACRA
    N-570 SHROUD 5/32" BLACK WIRE
    Murrays Sports
    Replacement Shroud for a Nacra 570
    N-570 SHROUD 5/32" BLACK WIRE
    Murrays Sports
    Replacement shroud for a 5.7 G-Cat.
    G-CAT 5.7 SHROUD
    Murrays Sports
    Oxen Block Main Paw Pin Murrays Part# 005-0761-29
    OXEN BLOCK MAIN PAW PIN
    Oxen
    Out of Stock
    N17 Hard Batten Set Murrays Part# 56-31675 This is a full batten set for the NACRA 17 MKii Olympic Class Catamaran. For use in heavier breeze conditions.
    NACRA 17 HARD BATTEN SET
    NACRA
    Out of Stock
    H20 Main Sail Batten Set Murrays Part# 50-42000001 Hobie® factory replacement batten set for the Hobie 20 Stock batten lengths: #8 (top) 31" #7 47" #6 60" #5 76" #4 87" #3 93.5" #2 97" #1 (bottom) 96"
    H-20 MAIN SAIL BATTEN SET
    Hobie
    H14 Line Package Comptip Murrays Part# 001-3914C This is a replacement line package for your Hobie 14 with a comptip.  Line Package Includes:  Main Halyard Comp-Tip Style  Mainsheet 3/8" 42' Downhaul 3/16" VLS 5' Outhaul 3/16" VLS 7.5' Tramp Center Lacing 1/4" 19' Tramp Rear Lacing 1/4" 15' Righting Line 1/2" 16'
    H-14 LINE PACKAGE COMP TIP
    Murrays Sports
    Harken 40 mm Zircon Block Murrays Part# 28-2190 ​Zircon blocks help trimmers match sail shapes to new conditions immediately. At the core of the Zircon performance are industrial ceramic ball bearings mounted inside caged races. The cages keep these bearings separated so they don’t bunch, touch, and stop each other. The result is the most efficient small boat block Harken has ever made. Zircon blocks are available in 40- and 57-mm sheaves in single and double blocks, with or without beckets.
    HARKEN 40MM ZIRCON BLOCK
    Harken
    Harken 57mm T2™ Soft-Attach Ratchamatic® Block-Red Sheave Murrays Part# 28-2160red Harken Block 57mm T2 Soft-Attach Ratchet Block for catamarans, this tie-on block eliminates the need for shackles, posts, swivels, etc. It is ultra-lightweight and sized like a bullet-block.
    HARKEN 57MM T2 SOFT-ATTACH RATCHAMATIC BLOCK-RED SHEAVE
    Harken
    Harken 57mm Ratchamatic HTE Block-Swivel, 1.5x Grip Murrays Part# 28-2165HTE ​The Harken Carbo Ratchamatic® is a load-sensing ratchet block that rolls freely in both directions under low loads and automatically engages the ratchet as loads increase. Shifting between ratchet and light-air modes is seamless. The spring on the HTE (high-threshold engage) version of the 57 mm Carbo Ratchamatic blocks was made stiffer to delay the point where the ratchet engages, allowing the block to run free more of the time
    HARKEN 57MM RATCHAMATIC HTE BLOCK-SWIVEL, 1.5X GRIP
    Harken
    Out of Stock
    H14 Main Batten Set Murrays Part# 46-3011 Hobie factory saturn shaped fiberglass battens for a Hobie 14 main sail. They are cut to length and can be shortened as necessary for your sail. This is how Hobie makes their sets! Batten caps are included.
    H-14 MAIN BATTEN SET
    Murrays Sports
    Rivet CCP 4-6 (1/8 X 3/8) Murrays Part# 19-5030 Stainless steel 1/8" x 3/8" rounded pan head rivet.
    RIVET CCP 4-6 (1/8 X 3/8)
    Misc
    Out of Stock
    Nacra Center Post Bridle Foil Murrays Part# 56-9663 Center post for Nacra bridle foil. Performance Sports factory #9663 Nacra Sailing #30303.
    NACRA CENTER POST BRIDLE FOIL
    Murrays Sports
    Recently viewed