Bravo Mast Parts

Bravo Mast Parts

9 products
    9 products
    Out of Stock
    Mast Bravo Lower T/F
    Hobie
    Out of Stock
    Bravo Mast Float w/straps and buckles
    Hobie
    Out of Stock
    Comptip Hobie Bravo
    Hobie
    Out of Stock
    Bravo A-Frame Support W/ Strap
    Hobie
    Out of Stock
    Bravo Knob assembly Mast Gate
    Hobie
    Hobie rivet casings sleeves seal rivets to prevent water penetration. When used with a rivet they seal the hole to prevent water from getting through the center of the rivet. Rivet Casings are recommended for use on all rivets on the mast to keep the mast water tight. Compatible with all 3/16 diameter rivets up to 5/8" long. Compatible with all rivets on Hobie, Nacra and Prindle catamarans except traveler tracks. Requires 13/64" hole. Hobie part number 8011291, 8011290, also called rivet cap.
    RIVET CASING 6-10(3/16 X 5/8)
    Hobie
    Nut Nylock 5/16-18 Stainless Steel Murrays Part# 19-2520 5/16-18 nylock nut is used on Hobie® rudders. The stainless steel hex nut with nylock insert will not rust or work loose if properly installed. Compare to Hobie Cat® item #8050311 and 8050321 shroud anchor pin nut Used with Hobie Getaway Bow Tang Bolt
    NUT NYLOCK 5/16-18 (SS)
    Misc
    Screw RHMS 1/4-20 X 1/2" Stainless Steel Murrays Part# 19-3019 Stainless steel, Phillips pan head 1/4-20 x 1/2" machine screw is used to fasten mast bearing on post-1990 Hobie® 18. Compare to Hobie 8032011
    SCREW RHMS 1/4-20 X 1/2" (SS)
    Misc
    Nut Nylock Lo-Pro 1/4-20 Murrays Part# 50-8050101 Hobie® factory replacement low profile 1/4-20 nylock nut. Used on Hobie 14 and 16 gooseneck assembly. Hobie Part# 8050101
    NUT NYLOCK LOW PROFILE 1/4-20"
    Hobie